Ask the Rebuilder

AskTheRebuilder => Alternator Questions => Topic started by: Juha on August 14, 2013, 06:12:44 PM

Title: Where to install the FRM for jeep vehicles
Post by: Juha on August 14, 2013, 06:12:44 PM
I think that it should be installed in between the two wires you cut when installing the external regulator on the side  that would not be used. " Bosch alternator schematics.".
Title: Re: Where to install the FRM for jeep vehicles
Post by: drew on August 19, 2013, 02:53:33 PM
The FRM attaches to your old regulator connections. I have attached a simple diagram. There are some things to be sure of before you install the FRM:


Then you wire up the FRM to your old regulator connections. Be sure these only connect to the FRM, make sure they aren't connected to the alternator regulator connections or grounded. Also, don't use any tape on the FRM connections, as they can heat up.